Women M (bust 93 cm)

Button-up shirt with bust pattern, women's size M (93 cm bust)

Classic button-up shirt adapted for the bust, with a full bust adjustment.

Button-up shirt with bust – Women M (bust 93 cm)
Full pattern with 1 cm seam allowance · 133 × 85 cm
12pattern pieces
27pieces to cut
≈ 1.75 ydof main fabric (60" wide)

You will also need: interfacing.

Sewing instructions

General steps to sew this garment. Seam allowance is 1 cm (3/8") unless stated otherwise.

Supplies

  • Shirting (poplin, oxford, linen)
  • Fusible interfacing
  • Buttons
  • Matching thread and the right needle
  1. Prewash and press your fabric before cutting so it will not shrink after sewing.
  2. Print the pattern at 100%, check the test square and cut the pieces following the cutting list. Transfer notches, darts and button marks.
  3. Sew the darts from the edge to the point, tie off without backstitching and press them toward the center.
  4. Press and sew the button and buttonhole plackets on the fronts.
  5. Attach the yoke with the "burrito" method: back between the two yoke layers, then the front shoulders.
  6. Interface the collar and stand. Sew the collar, turn, topstitch and sandwich it between the stand layers; attach the stand to the neckline.
  7. Slash the sleeve vent and sew the sleeve placket (overlap and underlap pieces).
  8. Set the sleeves flat with a flat-felled or serged seam.
  9. Sew the underarm and side seam in one go, matching the armhole seams.
  10. Interface the cuffs, sew, turn and attach them to the sleeves, matching the pleats.
  11. Hem: double-fold to the inside, press and topstitch or blind stitch.
  12. Mark and sew the buttonholes, then sew on the buttons opposite them.

Cutting list

PieceCutMaterial
Back1× on the foldMain fabric
Collar and undercollar1×Main fabric
Collar and undercollar1×Main fabric
Collar and undercollar1×Interfacing
Collar and undercollar1×Interfacing
Collar stand2×Main fabric
Collar stand2×Interfacing
Cuff4×Main fabric
Cuff2×Interfacing
Sleeve2×Main fabric
Sleeve placket overlap2×Main fabric
Sleeve placket underlap2×Main fabric
Yoke2×Main fabric
Buttonhole placket1×Main fabric
Button placket1×Main fabric
Front right1×Main fabric
Front left1×Main fabric

Measurements used in this size

MeasurementValueHow to measure
Biceps circumference27 cmAround the widest part of the relaxed upper arm.
Chest/bust circumference92.5 cmAround the torso at the fullest part of the chest, tape level.
Shoulder to bust27.5 cmFrom the high point of the shoulder (next to the neck) to the bust point.
Back length39.5 cmFrom the high shoulder point, down the back, to the waist.
Neck circumference34 cmAround the base of the neck, where a shirt collar sits.
Shoulder width41.5 cmFrom one shoulder point to the other, across the back.
Shoulder slope13°Shoulder angle in degrees (usually between 10 and 15).
Waist to armpit17 cmVertically along the side, from the waist to the armpit.
Waist to hips12.5 cmAlong the side, from the waist to the hip line.
Waist circumference75 cmAround your natural waist, the narrowest part of the torso.
Hip circumference90 cmAround the hips, at the level of the hip bones.
High bust circumference86.5 cmAround the torso, under the armpits and above the bust.
Bust span16 cmHorizontal distance between the two bust points.
Arm length59 cmFrom the shoulder point to the wrist, arm slightly bent.
Wrist circumference16.5 cmAround the wrist, over the bone.

Between two sizes?

Standard sizes are a starting point. Enter your own measurements in the editor and the pattern is redrafted for your body in seconds, for free.

Open in the editor