Jackets & coats · Advanced
Denim jacket sewing pattern
Classic denim jacket with yoke and chest pockets.
Choose your size
Each size has its own page with the full pattern, the cutting list and the measurements used.
Women's sizes (with bust)
Pattern preview
Sewing instructions
General steps to sew this garment. Seam allowance is 1 cm (3/8") unless stated otherwise.
Supplies
- Denim or canvas
- Buttons
- Matching thread and the right needle
- Prewash and press your fabric before cutting so it will not shrink after sewing.
- Print the pattern at 100%, check the test square and cut the pieces following the cutting list. Transfer notches, darts and button marks.
- Use topstitching thread and a denim needle; finish seams with a decorative double topstitch.
- Attach the yoke with the "burrito" method: back between the two yoke layers, then the front shoulders.
- Prepare the patch pockets (hem the top, press the edges under) and topstitch them in place.
- Assemble the shell: back, side and shoulder seams; press each seam as you go.
- Sew the two-piece sleeve (top and under sleeve) and set it into the armhole, easing the cap.
- Interface the collar and stand. Sew the collar, turn, topstitch and sandwich it between the stand layers; attach the stand to the neckline.
- Interface the cuffs, sew, turn and attach them to the sleeves, matching the pleats.
- Mark and sew the buttonholes, then sew on the buttons opposite them.
Cutting list
| Piece | Cut | Material |
|---|---|---|
| Back panel | 1× on the fold | Main fabric |
| Back side | 2× | Main fabric |
| Back yoke | 1× on the fold | Main fabric |
| Cuff | 2× on the fold | Main fabric |
| Front facing | 2× | Main fabric |
| Front yoke | 2× | Main fabric |
| Front panel | 2× | Main fabric |
| Front side panel | 2× | Main fabric |
| Front inside | 2× | Main fabric |
| 4× | Main fabric | |
| Pocket flap | 4× | Main fabric |
| Top sleeve | 2× | Main fabric |
| Under sleeve | 2× | Main fabric |
| Under collar | 1× on the fold | Main fabric |
| Upper collar | 1× on the fold | Main fabric |
| Waistband | 1× on the fold | Main fabric |
Measurements needed
| Measurement | How to measure |
|---|---|
| Biceps circumference | Around the widest part of the relaxed upper arm. |
| Chest/bust circumference | Around the torso at the fullest part of the chest, tape level. |
| Shoulder to bust | From the high point of the shoulder (next to the neck) to the bust point. |
| Back length | From the high shoulder point, down the back, to the waist. |
| Neck circumference | Around the base of the neck, where a shirt collar sits. |
| Shoulder width | From one shoulder point to the other, across the back. |
| Shoulder slope | Shoulder angle in degrees (usually between 10 and 15). |
| Waist to armpit | Vertically along the side, from the waist to the armpit. |
| Waist to hips | Along the side, from the waist to the hip line. |
| High bust circumference | Around the torso, under the armpits and above the bust. |
| Hip circumference | Around the hips, at the level of the hip bones. |
| Seat circumference | Around the fullest part of the buttocks. |
| Seat back | Back part of the seat circumference, side to side. |
| Waist circumference | Around your natural waist, the narrowest part of the torso. |
| Waist back | Back part of the waist circumference, side to side. |
| Shoulder to elbow | From the shoulder point to the elbow, arm slightly bent. |
| Arm length | From the shoulder point to the wrist, arm slightly bent. |
| Wrist circumference | Around the wrist, over the bone. |
FAQ
Is the denim jacket pattern really free?
Yes. Every Kutopy pattern is free, with no sign-up and no watermarks. You can sew and sell what you make.
Which measurements do I need?
This pattern uses 18 body measurements. If you don't know them, pick a standard size or follow our measuring guide.
Does it include seam allowance?
Yes, it includes 1 cm (3/8") seam allowance (outer dashed line). You can remove it in the editor.
How do I print it at full scale?
In the editor pick your paper and tap "Download PDF". At home: numbered Letter or A4 pages you tape together. At a print shop or plotter: full size on one sheet, a 36" roll or large sheets. Always print at 100% and check the 10 × 5 cm test square.
